SURFACE PREPARATION

Products for the conditioning of the support to be coated with microcement, which guarantee a correct application.

Products for the conditioning of the support, which guarantee a correct application with guarantees. Primers, fiberglass mesh, etc.
  • Imprim + – adhesion promoter primer for non-absorbent surfaces
  • Imprim Sec – adhesion promoter primer for absorbent surfaces
  • Imprim-Protect – primer for uniform results without marks, before sealer
  • Fiberglass mesh – prevents cracks and consolidates the surface
  • Aluminum profile – reinforcement butt plate
Imprim +

Imprim + is an adhesion promoter primer for non-absorbent surfaces , applied before applying the micro-cement, acts as a bridge between the support and the microcement, improving the grip of the first coat of microcement on non-absorbent surfaces such as tiles, metal, marble or terrazzo.

Performance:
IMPRIM + (1 hand) → 0.09 l / m2

How to use:
Once applied, you must wait a minimum of 30 minutes and no more than 24 hours to apply the first coat of Microcement.

Imprim Sec
Imprim Sec is an adhesion promoter primer for absorbent surfaces, applied before microcement, acting as a bridge between the substrate such as plasterboard or gypsum and microcement.

Performance:
IMPRIM Sec (1 hand) → 0.10 l / m2

How to use:
Once applied, you must wait a minimum of 30 minutes and no more than 24 hours to apply the first coat of Microcement.

 

Imprim-Protect

The use of IMPRIM-PROTECT is recommended before applying the LUXURY  sealer. It acts as a primer to provide a uniform result without marks, preserves the appearance of the support and improves to some extent the performance of the sealants. We only recommend its use when it is sealed with LUXURY sealer.

Performance:
IMPRIM-PROTECT (1 hand) → 0.06 l / m2

How to use:
It is applied with short hair  roller in one hand. Let the microcement dry between 24 and 48 hours depending on the weather conditions. To measure the moisture content of the microcement you can use a moisture meter for mortars. The reading should not exceed 5%. After applying IMPRIM-PROTECT, wait 24 hours before applying LUXURY sealer (in two hands).

Fiberglass mesh

This thin and resistant mesh of flexible fiberglass special for microcement, reinforces continuous pavements and walls soldering the support to avoid cracks or unwanted cracks.
Being flexible and manipulable, it can also be used to reinforce edges on stairs or furniture.
Prevents the appearance of cracks in the meeting of two different materials such as the connection between a door frame and the wall.
It is essential to place this mesh when coating walls with old tiles to avoid cracks in the joints of these tiles.

 

Aluminum profile
Aluminum profile used as an aluminum butt plate to protect the profiles of the steps in microcement stairs.
It is also used in the corners of the walls to protect against chafing and wear.
Application: It is fixed to the step or edge with a first layer of LUXURY BASE microcement, covering its fixing surface with Fiberglass mesh. With the following LUXURY BASE layers, the level of the 4 mm butt plate is aligned.